| Model | 410 HP Bostik |
| D max (mm) | 1 |
| Applicable Thickness (mm) | 10 |
| Dry Unit Volume Weight (kg / l) | 1,4 ± 0,2 |
| Wet Unit Volume Weight (kg / l) | 1,8 ± 0,2 |
| Pot Life (min.) (at 20°C) | ~ 60 |
| Curing Time (hour) (at 20°C) | ~ 24 |
| Working Time (min) | ~ 30 |
| Compressive Strength (28 days) (N/mm2 ) | ≥ 10 |
| Flexural Strength (28 days) (N/mm2 ) | ≥ 2 |
| Water Mixing Ratio (for 25 kg dry mortar) | 5 – 6 l |
| Environment temperature for application | Between +5°C and +35°C |
| Colour | Grey |
| Packaging (kg) | 25 |
- Resistant to water, frost, humidity and adverse weather conditions
- Polymer reinforced
- Very strong adhesion on the surface
- High resistant
- Used for filling and repairing the gaps and cracks on the surface
- Provides a smooth surface with a fine layer application
- Eliminates levelling, filling and grading differences in the surface
- Long-term durable x Easy to apply
- Hydraulic bounding quality
- Fireproof
Areas of applications:
- Interior and exterior
- On walls and ceilings
- In exposed concrete surfaces
- In the repair of edges and corners
- In the repair of reinforced concrete construction elements, before covering ceramic and tiles
A cement-based, high performance concrete filling and repair mortar with synthetic resin and polymer that is prepared with the reinforcement of various additives and in compliance with R1 Class according to TS EN 1504- 3/04.2008. It is suitable for interior and exterior use manually.
Preparation of the substrate:
- The application surface should be crack-free and strong enough to bear itself.
- The separating substances such as dust, dirt, waste plaster and paint, slag, tar, cement residues and grease, etc. should be cleaned from the surface.
- Highly absorbent concrete surfaces should be primed with Bostik MultiPrim, the surfaces like exposed concrete should be primed with Bostik ContactPrimer before the application.
Application:
- Bostik 410 HP should be mixed with a low cycle mixer after pouring into a container filled with 5 – 6 lt of clean water at normal environment temperature until a smooth mixture is obtained. Mixing time should be minimum 5 minutes. The obtained mortar should be rested for 3 minutes and mixed for 3 minutes again in order to obtain a homogenous mixture.
- The mixed mortar is ready to apply after an aging period of 3 minutes.
- The fresh mortar is spread with a steel trowel. x Optionally the plastered surfaces is wetted with water and smoothened by pressing with a steel trowel and as a result a smooth surface like exposed concrete is obtained.
After application: In order to avoid fast and unhealthy drying, the surfaces should be protected from direct sunlight and adverse air conditions such as heavy wind and frost. To obtain the recommended long term technical performance of the product, after the completion of the all application, the application and/or work should be covered and protected with a suitable coating or covering (paint, ceramic, tile etc…) as early as possible (depending on the product’s drying time within 3-7 days).
Coverage: Approx. 1,2 – 1,5 kg/m2 for 10 mm thickness.
* The coverage amounts are theoretical and it is recommended to do coverage-controlled sample application before treatment.